maybe, it is very diffilcult to find a MUX. Now, i want to find a switch to change among four outputs... Who can suggest me??? ( it is a switch with four inputs and one ouput)

Thanhks for reading...
My problem:  To design a phaseshift from 0 to 360 degree... it users microstrip technology
My idea: i have designed include 2 part
part one: i desgined a Hybrid 90  degree phase shift that uses varactor to control phase at output. But It changes from 0 to 90 degree So..
Part two: I desgned a power divider. I uses wilkilson  power splitte one input and four outputs....
My question:. I want to find a switch  that has 4 inputs and one output to couple with Wilkilson power spliter....

I have used ADS software to desgin

to Pancho
Maybe  you don't understand what i said and done
the first: I need to find a switch or mutiplexer at output
the second: I have to design real circuit  
but, you can explaint clearly  what you want to say.

I assume you use Agilent Momentum on Agilent ADS.
But you can do your task by using distributed components elements without using Momentum.

If you would like to design Hybrid alone, do 4port S-parameter analysis.

If you would like to design 1:4 power divider alone, do 5port S-parameter analysis.

If you would like to design a combination of Hybrid and 1:4 power divider, do 7port S-parameter analysis.

hieuphong wrote on Nov 11^th, 2010, 7:42am:
I don't think any switch or multiplexer is required in designing.

hieuphong wrote on Nov 11^th, 2010, 7:42am:
Do you want to design actual SP4T switch ?
I think your designing targets are Hybrid and 1:4 Power Divider not SP4T switch.

However if you would like to use switch, use the following as three cascaded blocks.
http://edocs.soco.agilent.com/display/ads2009U1/SPDT+Static+%28Single+Pole+Doubl....

Or create your own switch by using Verilog-A.


Again, do you think your power dividers can work properly without termination ?
If you use "multiplexer", you have to terminate all unused outputs.

This is very true even if you implement actual switch using pin-diode.

This is very true even if you use commercial product of SP4T switch such as followings.
http://www.analog.com/static/imported-files/data_sheets/ADG904_904R.pdf
http://www.peregrine-semi.com/pdf/datasheets/pe42641ds.pdf

And this is also true for Hybrid.

Again, I don't think any switch or multiplexer is required at all in your designing tasks.

Nobody want to help me. I'm desiging the hardware of project. But i have some diffilcults. it's not matching between input character and output character. I have designed about 5 verisons. Who can give me some advises, please? If i don't complete i can't graduate... Help me, please!!!!!