The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines. Dec 14th, 2017, 8:40am
  HomeHelpSearchLoginRegisterPM to admin  
 
Pages: 1
Send Topic Print
How to extract the R, L, C components of two interconnect wires from spectre sim (Read 39 times)
reneezl
New Member
*
Offline



Posts: 1

How to extract the R, L, C components of two interconnect wires from spectre sim
Dec 06th, 2017, 5:12am
 
Hello,

In my design, there are two interconnect wires.
a1----b1
a2----b2
I run extraction and generate the s-parameter file - wires.s4p.

I tried to run sp simulation in ADE to extract the R, L and K, coupling capacitance (Cc), and capacitance to ground (Cgnd).

I could get
R = real(1/ypm('sp 1 1))

But for Cc, Cgnd, How can I do that?

If I define a1 as port1, a2 as port2, should Cc = imag(-ypm('sp 2 1))/(2*pi*xval(ypm('sp 2 1)))? Should I leave port b1, b2 to noConn?

Thank you very much!
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
Trouble viewing this site? Copyright © 2002-2014 Designer's Guide Consulting. 'Designer's Guide' is a registered trademark of Designer's Guide LLC. All rights reserved.

Our colleges are not as safe as they seem. Sexual assault is pervasive and the treatment of the victim by the adminstration is often as damaging as the assault: Campus Survivors, Campus Survivors Forum.

Some of our other sites that you might find useful: Avendesora and QuantiPhy.