blue111 Community Member Offline Posts: 81	Terminal Impedance Modification using Feedback Jun 23rd, 2017, 2:47am   Why is it (gm2)*(Rd) instead of (gm2)*1/(gm1 + gmb1) ?
Back to top	« Last Edit: Jun 23rd, 2017, 8:27am by blue111 »     IP Logged

Forum Jump » » 10 most recent Posts » 10 most recent Topics Design  - RF Design »» Analog Design   - Mixed-Signal Design   - High-Speed I/O Design   - High-Power Design   - Mixed-Technology Design Analog Verification  - Analog Functional Verification   - Analog Performance Verification Measurements  - RF Measurements   - Phase Noise and Jitter Measurements   - Other Measurements Modeling  - Semiconductor Devices   - Passive Devices   - Behavioral Models   - Transmission Lines and Other Distributed Devices Design Languages  - Verilog-AMS   - VHDL-AMS Simulators  - Circuit Simulators   - RF Simulators   - AMS Simulators   - Timing Simulators   - System Simulators   - Logic Simulators Other CAD Tools  - Entry Tools   - Physical Verification, Extraction and Analysis   - Unmet Needs in Analog CAD General  - Tech Talk   - News   - Comments and Suggestions   - Opportunities

Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.