The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Mar 29th, 2024, 6:43am
Pages: 1
Send Topic Print
Spectre netlisting issue with config view (Read 1066 times)
AMS_ei
Community Member
***
Offline



Posts: 67

Spectre netlisting issue with config view
Mar 18th, 2017, 9:45pm
 
Hi,

I have created a config view in which I have kept a subckt definition ( instance I39 as shown in the attachment) as verilog view.
When I generated a netlist by choosing a spectre simulator, I observed that name of the subckt for the instance I39 is vanished and a new word "subcircuit" appears in that place as shown in the attachment.

Could you please explain me is it the issue with the verilog view itself?
or some more settings are required to generate the netlist from config view?

Thank you.
Kind regards,
Back to top
 

spectre_netlist_error.png
View Profile   IP Logged
Andrew Beckett
Senior Fellow
******
Offline

Life, don't talk to
me about Life...

Posts: 1742
Bracknell, UK
Re: Spectre netlisting issue with config view
Reply #1 - Mar 20th, 2017, 8:19am
 
Do you really mean verilog? Spectre can't simulate Verilog (it actually does support structural verilog, but this isn't supported from ADE - not normally needed in an ADE flow) - it does support Verilog A, but not generic Verilog. It's a circuit simulator, not a logic simulator.

Regards,

Andrew.
Back to top
 
 
View Profile WWW   IP Logged
AMS_ei
Community Member
***
Offline



Posts: 67

Re: Spectre netlisting issue with config view
Reply #2 - Mar 21st, 2017, 6:01pm
 
Thank you Andrew for your valuable inputs.
Yes, I agree with you.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.