The Designer's Guide Community
Forum
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines. Apr 24th, 2017, 3:47pm
  HomeHelpSearchLoginRegisterPM to admin  
 
Pages: 1
Send Topic Print
openign SST2 file during simulation with Ultrasim (Read 640 times)
AMS_ei
Community Member
***
Offline



Posts: 48

openign SST2 file during simulation with Ultrasim
Aug 19th, 2016, 7:25am
 
Hi,

I am new AMS-designer with ultrasim flow. I am able to run the ultrasim.
I have checked the log file as well and found that, it is saying "opening the SST2 file amscf_CFG4.tmp.trn".

I'm not sure how the amscf_CFG4.tmp.trn file has been generated and why this file is required to ultrasim?

Could anyone please guide me.

Thank you.

Warm regards.
Back to top
 
 
View Profile   IP Logged
Pages: 1
Send Topic Print
Trouble viewing this site? Copyright © 2002-2014 Designer's Guide Consulting. 'Designer's Guide' is a registered trademark of Designer's Guide LLC. All rights reserved.
Give back to the Designer's Guide Community by shopping at Amazon. Purchasing products through this link helps to fund our activities and does not increase your cost.

Our colleges are not as safe as they seem. Sexual assault is pervasive and the treatment of the victim by the adminstration is often as damaging as the assault: Campus Survivors, Campus Survivors Forum.