The Designer's Guide Community
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines. May 25th, 2017, 3:34am
  HomeHelpSearchLoginRegisterPM to admin  
Pages: 1
Send Topic Print
ADS momentum hangs during EM simulation of balun (Read 1000 times)
Senior Member

Posts: 181

ADS momentum hangs during EM simulation of balun
Mar 15th, 2016, 12:55pm
I am trying to simulate a balun in TSMC65nm process using momentum. Smaller baluns simulate well. But when balun is large it hangs. Is there any solution?

Should I reduce layers in the substarte by calculating average permitivity?

I am using windows 7 and RAM is 12GB.
Back to top
View Profile   IP Logged
Pages: 1
Send Topic Print
Trouble viewing this site? Copyright © 2002-2014 Designer's Guide Consulting. 'Designer's Guide' is a registered trademark of Designer's Guide LLC. All rights reserved.
Give back to the Designer's Guide Community by shopping at Amazon. Purchasing products through this link helps to fund our activities and does not increase your cost.

Our colleges are not as safe as they seem. Sexual assault is pervasive and the treatment of the victim by the adminstration is often as damaging as the assault: Campus Survivors, Campus Survivors Forum.