The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
Apr 19th, 2024, 10:48pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Modeling › Passive Devices › Spice model of transformer
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
Spice model of transformer (Read 7343 times)
jcc
New Member
*
Offline



Posts: 1
vvvvv
Spice model of transformer
Apr 18th, 2011, 8:17pm  
Hi ,
   I'd like to know how to make a center-tapped transformer spice model for my design. In my design , there is a need to use push-pull method for driving a center-tapped transformer with turn ratio 8:1. Where can I get a reference model ?
Back to top
 
 
View Profile   IP Logged
lopezs
New Member
*
Offline



Posts: 1
Washington
Re: Spice model of transformer
Reply #1 - Sep 6th, 2011, 5:05am  
Hey just go below link you will get the whole idea of building
center-tapped transformer spice model:

orcad.com/documents/community.faqs/pspice/020445.aspx
Back to top
 
 
Tim Manning NZ
View Profile   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.