The Designer's Guide Community Forum - jitter simualtion with load or without load...

The Designer's Guide Community

Forum

	Forum	Verilog-AMS	Analysis	Modeling	Design	Theory	Books

Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.

Sep 9^th, 2010, 7:17pm

The Designer's Guide Community Forum › Measurements › Phase Noise and Jitter Measurements › jitter simualtion with load or without load...

‹ Previous topic | Next topic ›

Pages: 1

Send Topic

Print

jitter simualtion with load or without load... (Read 381 times)

somisetty Community Member Offline Posts: 61	jitter simualtion with load or without load... Jan 27^th, 2010, 3:02am Hi, i am simulating USB 2.0 Full Speed Driver for Jitter measurement.Is the simulaiton setup correct or not..i mean do i need to use the capacitive load or not...(USB 2.0 Full Speed driver Cap load is 50pF...) Thanks
Back to top	jitter_setup.JPG IP Logged

love_analog Community Member Offline Posts: 77	Re: jitter simualtion with load or without load... Reply #1 - Apr 20^th, 2010, 7:56am I am not familiar with the spec. In general you want to put the load since this will change the rise and fall time - which in turn does impact jitter.
Back to top	IP Logged

Pages: 1

Send Topic

Print

‹ Previous topic | Next topic ›

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.

Trouble viewing this site?

Copyright © 2002-2009 Designer's Guide Consulting. 'Designer's Guide' is a registered trademark of Designer's Guide LLC. All rights reserved.

Give back to the Designer's Guide Community by shopping at Amazon. Purchasing products through this link helps to fund our activities and does not increase your cost.