The Designer's Guide Community
Forum
ForumVerilog-AMSAnalysisModelingDesignTheory
Welcome, Guest. Please Login or Register. Please follow the Forum guidelines.
May 6th, 2024, 5:09pm
 
  HomeHelpSearchLoginRegisterPM to admin    
The Designer's Guide Community Forum › Simulators › Circuit Simulators › stb analysis with mutiple loops
‹ Previous topic | Next topic ›
Pages: 1
Send Topic Print
stb analysis with mutiple loops (Read 6850 times)
parth_sv
New Member
*
Offline



Posts: 6
stb analysis with mutiple loops
Jan 30th, 2008, 11:12pm  
Hello All,
   I am trying to STB analysis in a multi-loop system. Iprobe is in feedback path there are actually two loops seen. Will stb analysis take care of both these loops?

Thanks in Advance,
Partha
Back to top
 
 
View Profile   IP Logged
Frank Wiedmann
Community Fellow
*****
Offline



Posts: 678
Munich, Germany
Re: stb analysis with mutiple loops
Reply #1 - Jan 31st, 2008, 12:13am  
Stb analysis can only be used for multi-loop circuits if there is a critical wire in the circuit that breaks all loops and if you place the stb probe in this wire. Please see the section titled "Applicability of Loop-Based and Device-Based Algorithms" in http://www.kenkundert.com/docs/cd2001-01.pdf for details. You might also be interested in the recent discussion at http://www.designers-guide.org/Forum/YaBB.pl?num=1198131494;start=all.
Back to top
 
 
View Profile WWW   IP Logged
Pages: 1
Send Topic Print
‹ Previous topic | Next topic ›
« Home ‹ Board
The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.
Copyright 2002-2024 Designer’s Guide Consulting, Inc. Designer’s Guide® is a registered trademark of Designer’s Guide Consulting, Inc. All rights reserved. Send comments or questions to editor@designers-guide.org. Consider submitting a paper or model.