The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Entry Tools >> DRC error for Nwell resistor in UMC 130
https://designers-guide.org/forum/YaBB.pl?num=1533732366

Message started by abhilash_172 on Aug 8th, 2018, 5:46am

Title: DRC error for Nwell resistor in UMC 130
Post by abhilash_172 on Aug 8th, 2018, 5:46am

Hi everyone,

when i look at the layout of the pcell ,there is space between the last contact on one terminal and edge of diffusion, but when i load that instance in layout , the last contact is appearing at the edge of diffusion, DRC is giving a min space error.
i checked for NMOS and PMOS, layout is same as pcell. Did anyone face this issue before ?
i uploaded the pic below.

Regards
Abhilash

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.