The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Measurements >> RF Measurements >> Calibration Technique for RF Chemical Sensor
https://designers-guide.org/forum/YaBB.pl?num=1492427964

Message started by Usman Khalid on Apr 17th, 2017, 4:19am

Title: Calibration Technique for RF Chemical Sensor
Post by Usman Khalid on Apr 17th, 2017, 4:19am

Hello!

I have recently finished designing of my electromagnetic resonator. It is 4 port structure using 4 circular QMSIW antennas which are isolated from each other but are constructed on the same substrate. Picture is attached

My requirement is to make a calibration standard using at least 3 ports or 2 ports for calibration and then the remaining 1 port or 2 ports for chemical sensing using microfluidic channels.

So, it will be a chemical sensor device using calibration standard.

Can anyone please help me in how to make calibration standard in this scenario.

I read some papers on calibration techniques used for moisture detection from granular materials but I did not get an idea of how to use calibration technique in chemical sensing scenario.

Please help!

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.